Dec 31, 2009

How to configure the Gateway/Gatekeeper using Cisco routers?

[gatekeeper.jpg]

Configuration on Gatekeeper
Gatekeeper(config)#
 
Gatekeeper(config)# gatekeeper
 
Gatekeeper(config-gk)# zone local Gatekeeper abc.com
 
Gatekeeper(config-gk)# no shutdown 
 
Configuration on Gateway Router-A
Router-A(config)# 
 
Router-A(config)#gateway
 
Router-A(config)#interface Ethernet 0/0
 
Router-A(config)# h323-gateway voip interface
 
Router-A(config)# h323-gateway voip id Gatekeeper ipaddr 200.100.10.1
 
Router-A(config)# h323-gateway voip h323-id Router-A.abc.com
 
Router-A(config)#exit
 
Router-A(config)# dial-peer voice 10 pots
 
Router-A(config-dial-peer)# destination-pattern 1111
 
Router-A(config-dial-peer)# port 1/0/0
 
Router-A(config-dial-peer)# exit
 
Router-A(config)# dial-peer voice 12 voip
 
Router-A(config-dial-peer)# destination-pattern 2222
 
Router-A(config-dial-peer)# session target ras
 
Router-A(config-dial-peer)# exit 
 
Configuration on Gateway Router-B
Router-B(config)# 
 
Router-B(config)#gateway
 
Router-B(config)#interface Ethernet 0/0
 
Router-B(config)# h323-gateway voip interface
 
Router-B(config)# h323-gateway voip id Gatekeeper ipaddr 200.100.10.1
 
Router-B(config)# h323-gateway voip h323-id Router-B.abc.com
 
Router-B(config)#exit
 
Router-B(config)# dial-peer voice 10 pots
 
Router-B(config-dial-peer)# destination-pattern 2222
 
Router-B(config-dial-peer)# port 1/0/0
 
Router-B(config-dial-peer)# exit
 
Router-B(config)# dial-peer voice 12 voip
 
Router-B(config-dial-peer)# destination-pattern 1111
 
Router-B(config-dial-peer)# session target ras
 
Router-B(config-dial-peer)# exit  
Use the show gatekeeper endpoints command on the gatekeeper to verify that the two gateways have registered.
Gatekeeper# show gatekeeper endpoints

0 comments

Post a Comment